TCU

TCU & DSG tuning files

A tuned engine needs a gearbox that can keep up. We raise torque limits and adjust shift behaviour in the transmission control unit to match the engine file.

What we change

Torque limits

Transmission torque limits raised so the gearbox doesn't cut power after an engine tune.

Shift points and speed

Upshift and downshift points and shift times adjusted for normal, sport and manual modes.

Clutch pressure

Clutch clamping pressure adapted to the higher torque, to prevent slip.

Launch and kick-down

Launch control settings and kick-down behaviour set to how the car is used.

Matched to the engine file

Best done together with the ECU file, so engine and gearbox work as one.

From original file to flashed car

No accounts, no credit packs to buy up front. Leave a request, send the file, get it back.

  1. 01

    Read the ECU

    Make a full read or OBD read with your tool and keep the original as a backup.

  2. 02

    Send the ORI

    Send the file with the VIN or vehicle, ECU type, tool used and what you need done.

  3. 03

    We calibrate

    An engineer edits the maps by hand, corrects checksums and checks the file before it leaves.

  4. 04

    Flash and drive

    Write the file back, test drive, send us logs if you want a fine-tune. Support is included.

Other services

ECU

Stage 1

Optimised boost, fuel, timing and torque limiters on stock hardware. Safe, smooth, daily-driver ready.

ECU

Stage 2 / 2+

Calibrations for downpipes, intercoolers, intakes and hybrid turbos — built around the parts on the car.

ECU

Eco tune

More low-end torque so drivers shift earlier — for fleets and vans where fuel costs matter.

Sound

Pops & bangs

Crackle maps with adjustable intensity and RPM window. Only on petrol engines with suitable exhausts.

Features

Launch & hardcut

Launch control, rev limiters, flat-shift and Vmax removal where the platform allows it.

Diag

DTC off

Selective fault code deactivation for removed or retrofitted components.

Features

Start-stop, flaps, sensors

Start-stop off, swirl flaps, O2 sensors, cold start and other single-function edits.

Questions about this service

Which gearboxes do you tune?

Common dual-clutch and torque-converter automatics used in cars and light commercial vehicles. Send the TCU type and software number and we confirm before you start.

Do I need a TCU tune after Stage 1?

Not always. Many cars are fine on Stage 1 alone. If the gearbox limits torque or slips, a TCU file solves it.

Can you do the ECU and TCU together?

Yes, and that is the best way. Send both reads in one request and we match them.

Send a request

Leave a request with the vehicle and ECU — we reply on the contact you leave, usually within minutes during working hours.

Telegram @remapwerk_bot Prefer Telegram? Message us there — you’ll get the request form in one tap.

Send a request