ECU

Stage 1 tuning files

A Stage 1 file built from your original read: more power and torque on stock hardware, with the protections of the factory calibration kept in place.

What we change

Boost and fuel

Boost targets, injection quantity and rail pressure raised within what the turbo and injectors can safely deliver.

Torque limiters

Driver's wish, torque limiters and smoke limiters adjusted so the extra torque actually reaches the wheels.

Ignition and lambda

On petrol engines, ignition and lambda targets are tuned with knock control left active.

Gearbox limits in mind

Torque is shaped to what the clutch and gearbox can handle. If the TCU limits torque, we tell you before you flash.

Checksums

The file comes back with checksums corrected and ready to write with your tool.

From original file to flashed car

No accounts, no credit packs to buy up front. Leave a request, send the file, get it back.

  1. 01

    Read the ECU

    Make a full read or OBD read with your tool and keep the original as a backup.

  2. 02

    Send the ORI

    Send the file with the VIN or vehicle, ECU type, tool used and what you need done.

  3. 03

    We calibrate

    An engineer edits the maps by hand, corrects checksums and checks the file before it leaves.

  4. 04

    Flash and drive

    Write the file back, test drive, send us logs if you want a fine-tune. Support is included.

Other services

ECU

Stage 2 / 2+

Calibrations for downpipes, intercoolers, intakes and hybrid turbos — built around the parts on the car.

ECU

Eco tune

More low-end torque so drivers shift earlier — for fleets and vans where fuel costs matter.

TCU

TCU / DSG

Raised torque limits, faster shifts, launch settings and kick-down tuning to match the engine file.

Sound

Pops & bangs

Crackle maps with adjustable intensity and RPM window. Only on petrol engines with suitable exhausts.

Features

Launch & hardcut

Launch control, rev limiters, flat-shift and Vmax removal where the platform allows it.

Diag

DTC off

Selective fault code deactivation for removed or retrofitted components.

Features

Start-stop, flaps, sensors

Start-stop off, swirl flaps, O2 sensors, cold start and other single-function edits.

Questions about this service

Is Stage 1 safe for daily driving?

Yes. Stage 1 keeps the factory hardware and protections. We stay within the limits of the turbo, injectors and clutch, and we check the file before it leaves.

Do I need any hardware changes?

No. Stage 1 is for stock hardware in good condition. If the car has a downpipe, intercooler or other parts fitted, ask for Stage 2 instead.

Can I get the original back?

Always keep your original read. You can flash it back at any time, and we can also return a stock-power file with only single functions changed.

Send a request

Leave a request with the vehicle and ECU — we reply on the contact you leave, usually within minutes during working hours.

Telegram @remapwerk_bot Prefer Telegram? Message us there — you’ll get the request form in one tap.

Send a request