Features

Launch control & hardcut files

Performance functions added to the engine calibration: launch control, rev limiter, flat-shift and speed limiter changes, where the ECU platform supports them.

What we change

Launch control

Set launch RPM for a consistent start. Can be combined with the TCU launch settings on automatic cars.

Hardcut rev limiter

A sharp rev limiter instead of the soft factory cut, for track use.

Flat-shift

Keep the throttle down while shifting on manual gearboxes, where supported.

Vmax

Speed limiter raised or removed where the platform and the tyres allow it.

Checksums

The file comes back with checksums corrected and ready to write.

From original file to flashed car

No accounts, no credit packs to buy up front. Leave a request, send the file, get it back.

  1. 01

    Read the ECU

    Make a full read or OBD read with your tool and keep the original as a backup.

  2. 02

    Send the ORI

    Send the file with the VIN or vehicle, ECU type, tool used and what you need done.

  3. 03

    We calibrate

    An engineer edits the maps by hand, corrects checksums and checks the file before it leaves.

  4. 04

    Flash and drive

    Write the file back, test drive, send us logs if you want a fine-tune. Support is included.

Other services

ECU

Stage 1

Optimised boost, fuel, timing and torque limiters on stock hardware. Safe, smooth, daily-driver ready.

ECU

Stage 2 / 2+

Calibrations for downpipes, intercoolers, intakes and hybrid turbos — built around the parts on the car.

ECU

Eco tune

More low-end torque so drivers shift earlier — for fleets and vans where fuel costs matter.

TCU

TCU / DSG

Raised torque limits, faster shifts, launch settings and kick-down tuning to match the engine file.

Sound

Pops & bangs

Crackle maps with adjustable intensity and RPM window. Only on petrol engines with suitable exhausts.

Diag

DTC off

Selective fault code deactivation for removed or retrofitted components.

Features

Start-stop, flaps, sensors

Start-stop off, swirl flaps, O2 sensors, cold start and other single-function edits.

Questions about this service

Does launch control damage the car?

Frequent launches load the clutch, driveshafts and gearbox. We set moderate launch RPM for road cars and higher values only on request.

Can you add these to my Stage 1 file?

Yes. Most customers order them together with Stage 1 or Stage 2.

Can you remove the speed limiter?

On many platforms, yes. Make sure the tyres are rated for the new top speed.

Send a request

Leave a request with the vehicle and ECU — we reply on the contact you leave, usually within minutes during working hours.

Telegram @remapwerk_bot Prefer Telegram? Message us there — you’ll get the request form in one tap.

Send a request